CAD CAM EDM DRO - Yahoo Group Archive

What's the best software for a CNC SHOPTASK setup (MILL & LATHE)

Posted by jas_mary
on 2004-08-04 20:17:59 UTC
Hi,
I am new to this group and just get a brand new shopmaster bridgemill
and a cnc kit from camtronics. I was wondering what was the best
software for a CNC SHOPTASK setup (MILL & LATHE. I use Mastercam V7
for programming.

I want to use BOTH the LATHE and MILL in CNC mode (not at the same
time...)

Please let me know your preferred choice.
Thanks, JAson :)

Discussion Thread

jas_mary 2004-08-04 20:17:59 UTC What's the best software for a CNC SHOPTASK setup (MILL & LATHE) gfull 2004-09-21 14:20:31 UTC Re: What's the best software for a CNC SHOPTASK setup (MILL & LATHE) AbbyKatt 2004-09-21 15:05:06 UTC Bleed Resistor... Do geckos need a fan? Robert Campbell 2004-09-21 16:39:05 UTC Re: [CAD_CAM_EDM_DRO] Bleed Resistor... Do geckos need a fan? R Rogers 2004-09-21 17:47:44 UTC Re: [CAD_CAM_EDM_DRO] Bleed Resistor... Do geckos need a fan? Robert Campbell 2004-09-21 18:08:26 UTC Re: [CAD_CAM_EDM_DRO] Bleed Resistor... Do geckos need a fan? turbulatordude 2004-09-21 18:15:50 UTC Re: Bleed Resistor... Do geckos need a fan? industrialhobbies 2004-09-21 19:25:51 UTC Re: Bleed Resistor... Do geckos need a fan? turbulatordude 2004-09-22 01:05:06 UTC Re: Bleed Resistor... Do geckos need a fan? Russ Waters 2004-09-22 12:05:21 UTC Re: [CAD_CAM_EDM_DRO] Re: Bleed Resistor... Do geckos need a fan? turbulatordude 2004-09-22 13:53:25 UTC Re: Bleed Resistor... Do geckos need a fan? Gregory Kamysz 2004-09-22 19:43:26 UTC Re: [CAD_CAM_EDM_DRO] Re: Bleed Resistor... Do geckos need a fan?