Re: [CAD_CAM_EDM_DRO] limits

Which CNC program?

They are all different and in some cases, it also depends on the switch
(break before make, break after make) as it sounds like you are trying to
use the same switch for both homing an limits.

As the movie robot said, "Need more input"

At 07:46 PM 8/16/2004, you wrote:

>I'm still having problems with my home switches, I think I get
>interference with my limits. The limits all work good. I have a DB1V2.0
>from Axxus Technologies. All my limits are hooked together both + & -
>hooked up normally closed as are all the home switches. any switch will
>break the chain. The polarity in the ini file is set to 1 . I have 4
>wires to the breakout board, two for the limits and two for the home. I
>hooked the 2 wires from the home switches to pin 12 which has both + and
>- terminals, I don't think the polarity should matter. I hooked the two
>wires from the limits to pin 13. In this config. I could not get out of
>e-stop so I added two jumper wires from pin 13 to pin 15 plus to plus
>and minus to minus. This works good for the limits but the home in
>weird. sometimes they will find the switch and work fine. sometimes they
>will find the switch but fail to back off the .100 I set in the ini.
>sometimes they just move .100 from where the are and home.
>I hope someone could help with this. Thank You
>
>

Bubba

OLDER THAN DIRT
Country Bubba
(Actually the inventor of Country and Bubba)
In God We Trust

axtein@...
LaGrange, GA

http://ns1.dicomm.net/~axtein/dro


[Non-text portions of this message have been removed]