Re: [CAD_CAM_EDM_DRO] limits

I am using EMC.

Art Eckstein wrote:

>
> Which CNC program?
>
> They are all different and in some cases, it also depends on the switch
> (break before make, break after make) as it sounds like you are trying to
> use the same switch for both homing an limits.
>
> As the movie robot said, "Need more input"
>
> At 07:46 PM 8/16/2004, you wrote:
> >I'm still having problems with my home switches, I think I get
> >interference with my limits. The limits all work good. I have a DB1V2.0
> >from Axxus Technologies. All my limits are hooked together both + & -
> >hooked up normally closed as are all the home switches. any switch will
> >break the chain. The polarity in the ini file is set to 1 . I have 4
> >wires to the breakout board, two for the limits and two for the home. I
> >hooked the 2 wires from the home switches to pin 12 which has both + and
> >- terminals, I don't think the polarity should matter. I hooked the two
> >wires from the limits to pin 13. In this config. I could not get out of
> >e-stop so I added two jumper wires from pin 13 to pin 15 plus to plus
> >and minus to minus. This works good for the limits but the home in
> >weird. sometimes they will find the switch and work fine. sometimes they
> >will find the switch but fail to back off the .100 I set in the ini.
> >sometimes they just move .100 from where the are and home.
> >I hope someone could help with this. Thank You
> >
> >
>
> Bubba
>
> OLDER THAN DIRT
> Country Bubba
> (Actually the inventor of Country and Bubba)
> In God We Trust
>
> axtein@...
> LaGrange, GA
>
> http://ns1.dicomm.net/~axtein/dro
>
> [Non-text portions of this message have been removed]
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
> Post Messages: CAD_CAM_EDM_DRO@yahoogroups.com
>
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@..., timg@...
> Moderator: pentam@... indigo_red@... davemucha@... [Moderators]
> URL to this group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>
> OFF Topic POSTS: General Machining
> If you wish to post on unlimited OT subjects goto: aol://5863:126/rec.crafts.metalworking or go thru Google.com to reach it if you have trouble.
> http://www.metalworking.com/news_servers.html
>
> http://groups.yahoo.com/group/jobshophomeshop I consider this to be a sister site to the CCED group, as many of the same members are there, for OT subjects, that are not allowed on the CCED list.
>
> NOTICE: ALL POSTINGS TO THIS GROUP BECOME PUBLIC DOMAIN BY POSTING THEM. DON'T POST IF YOU CAN NOT ACCEPT THIS.....NO EXCEPTIONS........
> bill
> List Mom
> List Owner
>
>
> Yahoo! Groups Links
>
>
>
>