CAD CAM EDM DRO - Yahoo Group Archive

RE: [CAD_CAM_EDM_DRO] Delta Tau PMAC card Used with EMC

Posted by Leslie Watts
on 2004-09-04 09:45:58 UTC
Hi Bryan

I have some good and bad news...

The Delta Tau card is not compatible with EMC.
EMC is a different concept that just uses an I/O
card and has the computer do all the calculations
with a special real-time operating system.

Now for better news....

The Card you have actually has a motion control
computer on it. The host pc is only used to communicate
with it. As such it does not need a real-time operating system.

The card might be worth some $ as well...

If you can tell me more about the card (model # etc) I can check
for compatible software.

Les

Leslie M.Watts
L M Watts Furniture
Tiger Georgia

Main page:
http://www.lmwatts.com
Engineering:
http://www.lmwatts.com/shop.html
Cnc surplus for sale:
http://www.lmwatts.com/forsale.html
Carved signs:
http://www.lmwatts.com/signwp.html

-----Original Message-----
From: bdrmachine [mailto:bdrmachine@...]
Sent: Saturday, September 04, 2004 10:06 AM
To: CAD_CAM_EDM_DRO@yahoogroups.com
Subject: [CAD_CAM_EDM_DRO] Delta Tau PMAC card Used with EMC


I purchased a used computer that has a (Delta TAU) PMAC-PC ISA card
that I would like to use to retrofit a lathe. I have no working
knowledge of this PMAC family of cards. From the initial
information I have on this card it appears that it would replace a
Servo-To-Go card. Has anyone used this card? Is there any EMC
information available for this card?

Thanks
Brian

Discussion Thread

bdrmachine 2004-09-04 07:05:44 UTC Delta Tau PMAC card Used with EMC Leslie Watts 2004-09-04 09:45:58 UTC RE: [CAD_CAM_EDM_DRO] Delta Tau PMAC card Used with EMC Paul 2004-09-04 10:13:31 UTC Re: [CAD_CAM_EDM_DRO] Delta Tau PMAC card Used with EMC tomp_tag@i... 2004-09-10 09:59:57 UTC RE: [CAD_CAM_EDM_DRO] Delta Tau PMAC card Used with EMC