Power supply source? Geckos/stepper combo
Posted by
Ken Gracey
on 2004-09-05 02:45:34 UTC
Hello,
I have a Wabeco D6000 lathe from MDAPrecision. I'm putting together a
Gecko system for two-axis control. These are the motor specifications:
Sanjo Denki
103-807-6241
12-300V
1.9A
Stall Torque 1.17nm
36V seems to be the typical voltage for these motors. I'm stuck on
the power supply. Would prefer to use an off-the shelf power supply.
Looks like I need 34-36V, 3-5A. I've checked JDR, Jameco, and a few
other surplus places. Any tips?
Thanks,
Ken
I have a Wabeco D6000 lathe from MDAPrecision. I'm putting together a
Gecko system for two-axis control. These are the motor specifications:
Sanjo Denki
103-807-6241
12-300V
1.9A
Stall Torque 1.17nm
36V seems to be the typical voltage for these motors. I'm stuck on
the power supply. Would prefer to use an off-the shelf power supply.
Looks like I need 34-36V, 3-5A. I've checked JDR, Jameco, and a few
other surplus places. Any tips?
Thanks,
Ken
Discussion Thread
Ken Gracey
2004-09-05 02:45:34 UTC
Power supply source? Geckos/stepper combo
turbulatordude
2004-09-05 03:15:07 UTC
Re: Power supply source? Geckos/stepper combo
Keith Clark
2004-09-05 05:31:18 UTC
Re: Power supply source? Geckos/stepper combo