Re: Motors moving so fast with Mach2 - stuck Z axis up too far
Posted by
Keith Clark
on 2004-09-12 17:17:01 UTC
Eureka, Clockwise and only a couple gentle taps and I am back in
business again!
Keith
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Keith Clark" <mail@t...>
wrote:
business again!
Keith
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Keith Clark" <mail@t...>
wrote:
> Larry, Here I go, glad it is possible to fix it. Reallyappreciate
> the advice, I had been really in the dumps, feeling low...
>
> Keith
>
> > >
> > I use a bar of soft metal (brass or alum) and a hammer.
> Stick the
> > bar into the teeth of the large
> > pulley around the screw at the front side of the pulley and
> give ...
> Larry
Discussion Thread
Keith Clark
2004-09-12 15:14:14 UTC
Motors moving so fast with Mach2 - stuck Z axis up too far
washcomp
2004-09-12 15:18:51 UTC
Re: Motors moving so fast with Mach2 - stuck Z axis up too far
Keith Clark
2004-09-12 16:29:19 UTC
Re: Motors moving so fast with Mach2 - stuck Z axis up too far
Larry Van Duyn
2004-09-12 16:46:04 UTC
Re: [CAD_CAM_EDM_DRO] Motors moving so fast with Mach2 - stuck Z axis up too far
Keith Clark
2004-09-12 16:54:10 UTC
Re: Motors moving so fast with Mach2 - stuck Z axis up too far
Keith Clark
2004-09-12 17:17:01 UTC
Re: Motors moving so fast with Mach2 - stuck Z axis up too far