Re: [CAD_CAM_EDM_DRO] die grinder

with the cheap grinders/routers available from Harbor Frt
it would seem that would be easier and not that expensive.
the grinders are usually pretty short and bearings are one
of the problems. No side pull on the air grinder so the bearings
may look good for the air grinder, but putting a side load on them
for the electric motor may make problems.
bob mcknight


Hi all,

has anyone modified a pneumatic die grinder for use with an electric
motor ?

I'm thinking that one could gain access to the shaft and use it to put
on a pulley and then have a shaft with bearings.

Dave



Addresses:
FAQ: http://www.ktmarketing.com/faq.html
FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
Post Messages: CAD_CAM_EDM_DRO@yahoogroups.com

Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com,
wanliker@...,
timg@... Moderator: pentam@...
indigo_red@... davemucha@... [Moderators] URL to
this
group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO

OFF Topic POSTS: General Machining
If you wish to post on unlimited OT subjects goto:
aol://5863:126/rec.crafts.metalworking or go thru Google.com to reach
it if you have trouble. http://www.metalworking.com/news_servers.html

http://groups.yahoo.com/group/jobshophomeshop I consider this to be
a sister site to the CCED group, as many of the same members are
there, for OT subjects, that are not allowed on the CCED list.

NOTICE: ALL POSTINGS TO THIS GROUP BECOME PUBLIC
DOMAIN BY POSTING
THEM. DON'T POST IF YOU CAN NOT ACCEPT THIS.....NO
EXCEPTIONS........
bill List Mom List Owner


Yahoo! Groups Links