Fadal Posts
Posted by
Howard Winther
on 2004-09-27 14:13:22 UTC
Received a fadal post from someone on this group.
It was MPFADAL for 1992 vintage Fadal using MasterCam.
Works fine except for subprograms. I used a post that I can not
find as my files were erased that did subprograms. The nc file
started like this N1000000 etc the MPFADAL post starts with 09999.
Got 680K files that I have to get down to < 460K.
When I do subprograms with the MPFADAL and look at the nc code
there are no subprograms, no P, no L just duplication.
Get the same result as transforming and I do checking subprogram.
If I can not solve I gues I will have to DNC the Program.
Looked into various programs but expensive $379.00
Program must be able to restart in middle in case of a broken tool.
Seems like a lot of money to buffer a program block, and It seems like
the mastercam program should be able to do it.
It was MPFADAL for 1992 vintage Fadal using MasterCam.
Works fine except for subprograms. I used a post that I can not
find as my files were erased that did subprograms. The nc file
started like this N1000000 etc the MPFADAL post starts with 09999.
Got 680K files that I have to get down to < 460K.
When I do subprograms with the MPFADAL and look at the nc code
there are no subprograms, no P, no L just duplication.
Get the same result as transforming and I do checking subprogram.
If I can not solve I gues I will have to DNC the Program.
Looked into various programs but expensive $379.00
Program must be able to restart in middle in case of a broken tool.
Seems like a lot of money to buffer a program block, and It seems like
the mastercam program should be able to do it.
Discussion Thread
Howard Winther
2004-09-27 14:13:22 UTC
Fadal Posts
volitan712003
2004-09-27 18:09:05 UTC
Re: Fadal Posts