Is this a blown Gecko?
Posted by
Mina Aboul Saad
on 2004-11-01 04:38:11 UTC
Hi,
I got a couple of geckos 320 for my lathe, I connected one of them to X axis
a couple of months ago, it has been working fine (not real work, just some
trials every now and then) until today I was taking some measurements with
my multimeter when I think I accidentally connected the +75VDC to the Arm+
terminal with the multimeter probe, nothing happened just a very small spark
on the probe, no smoke but the gecko would not work and also it heats up
very rapidly.
Is this a blown gecko? can it be fixed?
Please advise.
Mina F.
I got a couple of geckos 320 for my lathe, I connected one of them to X axis
a couple of months ago, it has been working fine (not real work, just some
trials every now and then) until today I was taking some measurements with
my multimeter when I think I accidentally connected the +75VDC to the Arm+
terminal with the multimeter probe, nothing happened just a very small spark
on the probe, no smoke but the gecko would not work and also it heats up
very rapidly.
Is this a blown gecko? can it be fixed?
Please advise.
Mina F.
Discussion Thread
Mina Aboul Saad
2004-11-01 04:38:11 UTC
Is this a blown Gecko?
Steven Ciciora
2004-11-02 07:48:56 UTC
Re: [CAD_CAM_EDM_DRO] Is this a blown Gecko?
mina_aboulsaad
2004-11-02 12:01:50 UTC
Re: Is this a blown Gecko?
Jon Elson
2004-11-02 21:42:54 UTC
Re: [CAD_CAM_EDM_DRO] Re: Is this a blown Gecko?