Re: Servo motor question

That what I am using on my full size mill. Except that the PRM is up around
1200 and the current is a bit higher. I am running two to 1 timing belts on
the X and Y axis and 3.5 to one on the kneee. I simply chucked up the drive
shaft and drilled the oposite end for a .250 hole, then press in a stub
shaft and then mount my encoder. Works slick.
Dan
-----Original Message-----
From: Tim Goldstein <timg@...>
To: CAD_CAM_EDM_DRO@onelist.com <CAD_CAM_EDM_DRO@onelist.com>
Date: Saturday, June 12, 1999 11:13 AM
Subject: [CAD_CAM_EDM_DRO] Servo motor question

>From: "Tim Goldstein" <timg@...>
>
>I was just a local salvage yard and they had a few DEC Magtape units that
>had what appeared to me to be servo motors to drive the tape reels.
>
>My question to you servo guru's (Matt, Jon, & ??) are these motors of any
>use for a servo setup? The marking were DC Motor, 24 v. 0.5 amp 600 rpm
>assembled by Indiana General.
>
>Tim
>[Denver, CO]
>
>
>------------------------------------------------------------------------
>ONElist members are using Shared Files in great ways!
>http://www.onelist.com
>Are you? If not, see our homepage for details.
>------------------------------------------------------------------------
>welcome to CAD_CAM_EDM_DRO@..., an unmodulated list for the

discussion of shop built systems in the above catagories.

>To Unsubscribe:
> http://www.onelist.com/unsubscribe/CAD_CAM_EDM_DRO
>bill, List Manager
>