Re: [CAD_CAM_EDM_DRO] Re: Servo motor question
Posted by
Jon Elson
on 2004-06-16 10:37:16 UTC
harry32002001 wrote:
go through the calculations on my own Bridgeport servo retrofit.
But, to condense it, my motors have a cont. rating of 73 Oz-In,
and I guesstimated a peak at 300 Oz-In. Now, I have a 2.5:1 belt
reduction ratio, so I get 182 and 730 Oz-In at the 5 TPI ballscrew.
This is marginal, but I'm not complaining. I do have some rounding-
off of corners, etc. due to the limited acceleration of the system.
Jon
>Thanks Les, Jon and all who replyed.Take a look at http://www.timgoldstein.com/cad_cam/motor.htm where I
>I guess the question I should of been asking is how much motor power
>(max and con.) should I have for average use on a seris 1 B.P.
>
>
go through the calculations on my own Bridgeport servo retrofit.
But, to condense it, my motors have a cont. rating of 73 Oz-In,
and I guesstimated a peak at 300 Oz-In. Now, I have a 2.5:1 belt
reduction ratio, so I get 182 and 730 Oz-In at the 5 TPI ballscrew.
This is marginal, but I'm not complaining. I do have some rounding-
off of corners, etc. due to the limited acceleration of the system.
Jon
Discussion Thread
Tim Goldstein
1999-06-12 11:25:43 UTC
Servo motor question
Matt Shaver
1999-06-12 11:34:32 UTC
Re: Servo motor question
Jon Elson
1999-06-12 22:55:22 UTC
Re: Servo motor question
Dan Mauch
1999-06-13 06:12:15 UTC
Re: Servo motor question
Mina Aboul Saad
2003-09-18 04:07:49 UTC
Servo motor question
Jon Elson
2003-09-18 08:26:08 UTC
Re: [CAD_CAM_EDM_DRO] Servo motor question
tomp_tag
2003-09-19 07:01:11 UTC
Re: [CAD_CAM_EDM_DRO] Servo motor question
harry32002001
2004-06-15 09:16:24 UTC
Servo motor question
Leslie Watts
2004-06-15 10:27:58 UTC
RE: [CAD_CAM_EDM_DRO] Servo motor question
David Paulson
2004-06-15 14:12:58 UTC
Re: [CAD_CAM_EDM_DRO] Servo motor question
harry32002001
2004-06-15 14:32:32 UTC
Re: Servo motor question
Jon Elson
2004-06-15 23:21:24 UTC
Re: [CAD_CAM_EDM_DRO] Re: Servo motor question
Leslie Watts
2004-06-16 06:10:11 UTC
RE: [CAD_CAM_EDM_DRO] Re: Servo motor question
harry32002001
2004-06-16 08:37:24 UTC
Re: Servo motor question
Jon Elson
2004-06-16 10:37:16 UTC
Re: [CAD_CAM_EDM_DRO] Re: Servo motor question