Re: [CAD_CAM_EDM_DRO] How to test stepping motors
Posted by
Alan Marconett
on 2004-11-23 10:12:46 UTC
Hi ?,
You need a driver for the stepper motor. Then run TurboCNC
Alan KM6VV
asdlkjdlafijadfgio wrote:
You need a driver for the stepper motor. Then run TurboCNC
Alan KM6VV
asdlkjdlafijadfgio wrote:
>
>
> I have my step motors and I have a PC. Is there some simple
> software I can load, and wire the motors to the parallel port to see
> if they will turn and and check direction?
>
> KB
>
Discussion Thread
asdlkjdlafijadfgio
2004-11-23 06:07:20 UTC
How to test stepping motors
Andy Wander
2004-11-23 06:39:06 UTC
RE: [CAD_CAM_EDM_DRO] How to test stepping motors
Alan Marconett
2004-11-23 10:12:46 UTC
Re: [CAD_CAM_EDM_DRO] How to test stepping motors
turbulatordude
2004-11-23 10:15:53 UTC
Re: How to test stepping motors
Andy Wander
2004-11-23 10:31:41 UTC
RE: [CAD_CAM_EDM_DRO] Re: How to test stepping motors
JanRwl@A...
2004-11-23 10:42:17 UTC
Re: [CAD_CAM_EDM_DRO] How to test stepping motors
Alan Marconett
2004-11-23 11:02:00 UTC
Re: [CAD_CAM_EDM_DRO] Re: How to test stepping motors
asdlkjdlafijadfgio
2004-11-23 17:19:12 UTC
Re: How to test stepping motors
JanRwl@A...
2004-11-23 23:00:20 UTC
Re: [CAD_CAM_EDM_DRO] Re: How to test stepping motors
turbulatordude
2004-11-24 06:58:23 UTC
Re: How to test stepping motors