Re: How to test stepping motors
Posted by
turbulatordude
on 2004-11-23 10:15:53 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, Alan Marconett <KM6VV@a...>
wrote:
connect them to the parallel port and TurboCNC can wave drive them.
Probably not the best, but for testing, it would be a simple way, no ?
Dave
wrote:
> Hi ?,I though one could make a simple circuit with some MOSFETS and then
>
> You need a driver for the stepper motor. Then run TurboCNC
>
connect them to the parallel port and TurboCNC can wave drive them.
Probably not the best, but for testing, it would be a simple way, no ?
Dave
Discussion Thread
asdlkjdlafijadfgio
2004-11-23 06:07:20 UTC
How to test stepping motors
Andy Wander
2004-11-23 06:39:06 UTC
RE: [CAD_CAM_EDM_DRO] How to test stepping motors
Alan Marconett
2004-11-23 10:12:46 UTC
Re: [CAD_CAM_EDM_DRO] How to test stepping motors
turbulatordude
2004-11-23 10:15:53 UTC
Re: How to test stepping motors
Andy Wander
2004-11-23 10:31:41 UTC
RE: [CAD_CAM_EDM_DRO] Re: How to test stepping motors
JanRwl@A...
2004-11-23 10:42:17 UTC
Re: [CAD_CAM_EDM_DRO] How to test stepping motors
Alan Marconett
2004-11-23 11:02:00 UTC
Re: [CAD_CAM_EDM_DRO] Re: How to test stepping motors
asdlkjdlafijadfgio
2004-11-23 17:19:12 UTC
Re: How to test stepping motors
JanRwl@A...
2004-11-23 23:00:20 UTC
Re: [CAD_CAM_EDM_DRO] Re: How to test stepping motors
turbulatordude
2004-11-24 06:58:23 UTC
Re: How to test stepping motors