CAD CAM EDM DRO - Yahoo Group Archive

Re: CAD Questions

Posted by jcc3inc
on 2004-12-09 06:21:36 UTC
To the Group:

Thanks for all your comments and suggestions. I have little CAD
experience so many of those details are unknown to me. At this point
the low cosd DeltaCad ($39) seems easier to use than Turbocad V6 when
it comes to making "parallel" lines around an arc. I'll need to get
a better understanding of *layers* too, to make using it easier.

Thanks again for your comments!

Jack C.

Discussion Thread

jcc3inc 2004-12-07 18:20:51 UTC CAD Questions Tom Hubin 2004-12-07 23:40:21 UTC Re: [CAD_CAM_EDM_DRO] CAD Questions Fred Smith 2004-12-08 04:49:33 UTC Re: CAD Questions caudlet 2004-12-08 06:30:02 UTC Re: CAD Questions R Rogers 2004-12-08 07:43:09 UTC Re: [CAD_CAM_EDM_DRO] CAD Questions turbulatordude 2004-12-08 09:17:48 UTC Re: CAD Questions caudlet 2004-12-08 15:04:42 UTC Re: CAD Questions jcc3inc 2004-12-09 06:21:36 UTC Re: CAD Questions turbulatordude 2004-12-09 09:17:20 UTC Re: CAD Questions Fred Smith 2004-12-10 07:03:47 UTC Re: CAD Questions