Re: etching/engraving PCB via a small CNC
Posted by
robot_csc364
on 2004-12-26 16:22:12 UTC
I found a XY table on ebay http://cgi.ebay.com/ws/eBayISAPI.dll?
ViewItem&category=25297&item=3843404692&rd=1&ssPageName=WD1V
if I use this with a electronics kit from say hobbyCNC.. that would
be pretty close to a complete setup? All I would have to add would
be a Z travel.
Let me know what yall think
Nick
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "robot_csc364"
<robot_csc364@y...> wrote:
ViewItem&category=25297&item=3843404692&rd=1&ssPageName=WD1V
if I use this with a electronics kit from say hobbyCNC.. that would
be pretty close to a complete setup? All I would have to add would
be a Z travel.
Let me know what yall think
Nick
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "robot_csc364"
<robot_csc364@y...> wrote:
>like
>
> I have a pretty good back ground in electronics, microcontrollers,
> and building autonomous robots.
>
> I do alot of prototyping for our robot team at Latech. I would
> to build a small CNC or engraver so I can make some PCB.do
>
> I came here because of a reference so I was hoping someone could
> help me.
>
> Some places I have found that have these kits are
>
> Stepperworld.com ( FET-3 )
> hobbycnc.com (
> http://www.hobbycnc.com/cncpackages...kg/4aupcpkg.htm )
>
> These are the motors and drivers, but are these good kits? Where
> I get the rails for the table?
>
> Thanks,
> Nick
Discussion Thread
robot_csc364
2004-12-26 14:31:28 UTC
etching/engraving PCB via a small CNC
robot_csc364
2004-12-26 16:22:12 UTC
Re: etching/engraving PCB via a small CNC
turbulatordude
2004-12-26 16:29:35 UTC
Re: etching/engraving PCB via a small CNC
JanRwl@A...
2004-12-26 20:20:54 UTC
Re: [CAD_CAM_EDM_DRO] etching/engraving PCB via a small CNC
John Labutski
2004-12-27 16:10:36 UTC
Re: etching/engraving PCB via a small CNC