CAD CAM EDM DRO - Yahoo Group Archive

Re: Flex Coupling; No Backlash.

Posted by lathehand_2
on 2005-01-26 07:15:51 UTC
As Always, Lets see if the thing works for before making an,
inventing the wheel again aproach. I like what I see and It suits me
fine after all the other options that I've gone through. Cost plays a
big part of things and downtime is, well we all been there and can
break or make a job. As said before, Let's see how long it will Last!
In my Last post, That was NOT concidered a Flame, In any Way, Shape,
or Form. 'I too could use a break'.

--- In CAD_CAM_EDM_DRO@yahoogroups.com, Andy Wander <awander@v...>
wrote:
> Lathehand:
>
>
> I think what you were saying was that there was no(or minimal)
backlash in
> the coupling. I misunderstood(and probably wrote too quickly) I
thought you
> meant it got rid of backlash in the leadscrew.
>
> Obviously, I;m workin; too hard.
>
> Andy
>
> Andy Wander
> Verrex Corporation
>
>
> -----Original Message-----
> From: lathehand_2 [mailto:lathehand_2@y...]
> Sent: Wednesday, January 26, 2005 9:35 AM
> To: CAD_CAM_EDM_DRO@yahoogroups.com
> Subject: [CAD_CAM_EDM_DRO] Re: Flex Coupling; No Backlash.
>
>
>
> Hello, OK, you MAYBE; right... but considering the use of
couplings,
> I BOUGHT, with the disk inserts, and the all so common plastic,
> nylon, and other polycarbonated configuration items to be found;
With
> trial and error, I have to differ, and accroding to my setup, and
> application, I find it, at least, a TOTAL Improvement for my Sake,
> OVER, what has Been Installed, and Time Involved, in getting a
> QUALITY Finish, and Repeatability. Your Right, Without
BackLash, 'It
> would'nt Move'.Then Again, Let's see how Long, it will Last. To Be
> Continued:
>
> --- In CAD_CAM_EDM_DRO@yahoogroups.com, Andy Wander <awander@v...>
> wrote:
> > How does it eliminate backlash? I would think, if anything, it
would
> > increase it(even if only ever so slightly)

Discussion Thread

lathehand_2 2005-01-25 15:52:51 UTC Flex Coupling; No Backlash. Andy Wander 2005-01-25 17:28:18 UTC RE: [CAD_CAM_EDM_DRO] Flex Coupling; No Backlash. lathehand_2 2005-01-26 06:35:17 UTC Re: Flex Coupling; No Backlash. Andy Wander 2005-01-26 06:54:13 UTC RE: [CAD_CAM_EDM_DRO] Re: Flex Coupling; No Backlash. lathehand_2 2005-01-26 07:15:51 UTC Re: Flex Coupling; No Backlash. Andy Wander 2005-01-26 07:23:25 UTC RE: [CAD_CAM_EDM_DRO] Re: Flex Coupling; No Backlash. vrsculptor 2005-01-26 12:32:44 UTC Re: Flex Coupling; No Backlash.