Re: Need software recommendation for motion control
Posted by
cnc_4_me
on 2005-01-26 15:32:06 UTC
http://www.dakeng.com/
TurboCNC - 8 axis CNC interpreter. Runs in DOS and provides
step/direction or direct phase control on the parallel port.
Mach2 Only 6 axis...
http://www.artofcnc.ca/product.html
Mach2 is a 45000Hz 6-Axis Controller for XP and 2000
Wally
TurboCNC - 8 axis CNC interpreter. Runs in DOS and provides
step/direction or direct phase control on the parallel port.
Mach2 Only 6 axis...
http://www.artofcnc.ca/product.html
Mach2 is a 45000Hz 6-Axis Controller for XP and 2000
Wally
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "dlpolan" <dpolan@c...> wrote:
>
> I am using (abusing) CNC Pro for something it was never intended
for,
> a motion control project that uses several stepper and servo motors.
>
> I will soon be needing to switch to software that can drive more
than
> four motors simultaneously. What recommendations are there for
> economical software that is flexible and can drive up to seven
> step/direction motors?
Discussion Thread
dlpolan
2005-01-26 14:37:11 UTC
Need software recommendation for motion control
JCullins
2005-01-26 14:57:50 UTC
Re: [CAD_CAM_EDM_DRO] Need software recommendation for motion control
cnc_4_me
2005-01-26 15:11:36 UTC
Re: Need software recommendation for motion control
A. G. Eckstein
2005-01-26 15:21:29 UTC
Re: [CAD_CAM_EDM_DRO] Need software recommendation for motion control
cnc_4_me
2005-01-26 15:32:06 UTC
Re: Need software recommendation for motion control
R Rogers
2005-01-26 15:40:31 UTC
Re: [CAD_CAM_EDM_DRO] Re: Need software recommendation for motion control
JCullins
2005-01-26 17:13:17 UTC
Re: [CAD_CAM_EDM_DRO] Re: Need software recommendation for motion control