Re: [CAD_CAM_EDM_DRO] ballscrew question,
Posted by
David A. Frantz
on 2005-02-09 09:30:15 UTC
Hi Mark;
Nope you don't need to support at both ends in all cases. Please note
the word ALL. In fact in some cases unless your alignment is
spectacularly good it may do more harm then good.
Dave
Nope you don't need to support at both ends in all cases. Please note
the word ALL. In fact in some cases unless your alignment is
spectacularly good it may do more harm then good.
Dave
On Wed, 2005-02-09 at 04:14 +0000, mark_anthony123 wrote:
>
>
> hi, do ballscrews have to be supported at both ends? Is there a
> certain length or rule of thumb? I was thinking of the z-axis for a
> homemade cnc router and the whole travel is only about 6 inches.
> what about a 20" travel, the most the screw would be hanging out at
> the end is 10". support it? I was looking at a mill/drill plan and
> I did not see pillow blocks on the free end. Thanks Mark.
>
>
>
>
>
>
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
> Post Messages: CAD_CAM_EDM_DRO@yahoogroups.com
>
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@..., timg@...
> Moderator: pentam@... indigo_red@... davemucha@... [Moderators]
> URL to this group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>
> OFF Topic POSTS: General Machining
> If you wish to post on unlimited OT subjects goto: aol://5863:126/rec.crafts.metalworking or go thru Google.com to reach it if you have trouble.
> http://www.metalworking.com/news_servers.html
>
> http://groups.yahoo.com/group/jobshophomeshop I consider this to be a sister site to the CCED group, as many of the same members are there, for OT subjects, that are not allowed on the CCED list.
>
> NOTICE: ALL POSTINGS TO THIS GROUP BECOME PUBLIC DOMAIN BY POSTING THEM. DON'T POST IF YOU CAN NOT ACCEPT THIS.....NO EXCEPTIONS........
> bill
> List Mom
> List Owner
>
>
> Yahoo! Groups Links
>
>
>
>
>
>
>
>
Discussion Thread
mark_anthony123
2005-02-09 02:48:24 UTC
ballscrew question,
David A. Frantz
2005-02-09 09:30:15 UTC
Re: [CAD_CAM_EDM_DRO] ballscrew question,
Henrik Olsson
2005-02-09 09:40:33 UTC
Re: [CAD_CAM_EDM_DRO] ballscrew question,
turbulatordude
2005-02-09 09:50:30 UTC
Re: ballscrew question,