Re: Jeff's mill drill

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "len_tikular" <george@p...>
wrote:

>
> I'd like to get in touch with Jeff. He has some pictures of his
> Mill/drill conversion in the 'Photos' section.
>
> Jeff maybe you could help me convert my Eagle25.
>
> Thanks
>
> George

Hi Gerorge, Dave here.


If Jeff doesn't reply, just review the list, get PGOFFLINE and pull
down the whole list so you can review it for each of yoru questions.


Check out a few other sites.

http://www.homecnc.info/ballscrew.htm

for screws replacement.

and

http://truetex.com/ymount.htm

for mounting motors

Much of this is straight forward cut and paste stuff.

Pick your strong suit, mechanical stuff, electronics, whatever and
start with that.

My one word of caution is to make sure that when one thing goes in,
it does not interfere with another.


There are other lists as well.

http://groups.yahoo.com/group/mill_drill/

If you are one of those guyse who likes to read every bit possible,
you may find that a 3-ring binder and print out all this stuff.
Seperate into sections.

If the last couple years of on-line searching, I think I can safely
say I have forgotten more web sites than most people can remember.

Dave