Re: [CAD_CAM_EDM_DRO] W.E.T. -CNC safety
Posted by
wthomas@g...
on 2005-03-06 12:22:05 UTC
Hi Jon and all:
May I suggest that you use no handle just a plain hand wheel
disk or a hand wheel with folding safety handle on any machine that
you will have the capaibility spin at a fast rate. The handles can
be a real hazzard if you get hit by them or they grab you shop apron.
Things get tight in a hurry!!!!!! I ran a Monarch lathe that had the
hand wheel disks only because it had rapid traverse both on the
carriage and the cross slide. It even had a pin to push into the
tail stock so you could pull or push back and forth to the end of the
bed at rapid traverse rate. Would it ever go! SAFE WORKING.
GOD'S BLESSINGS
Bill
May I suggest that you use no handle just a plain hand wheel
disk or a hand wheel with folding safety handle on any machine that
you will have the capaibility spin at a fast rate. The handles can
be a real hazzard if you get hit by them or they grab you shop apron.
Things get tight in a hurry!!!!!! I ran a Monarch lathe that had the
hand wheel disks only because it had rapid traverse both on the
carriage and the cross slide. It even had a pin to push into the
tail stock so you could pull or push back and forth to the end of the
bed at rapid traverse rate. Would it ever go! SAFE WORKING.
GOD'S BLESSINGS
Bill
Discussion Thread
eewhite42000
2005-03-05 14:33:15 UTC
To Convert or not to convert- That is the question!
ernie7
2005-03-05 14:37:58 UTC
Re: [CAD_CAM_EDM_DRO] To Convert or not to convert- That is the question!
Ron
2005-03-05 22:10:40 UTC
Re: To Convert or not to convert- That is the question!
Jon Elson
2005-03-05 22:15:15 UTC
Re: [CAD_CAM_EDM_DRO] To Convert or not to convert- That is the question!
Polaraligned
2005-03-06 04:47:36 UTC
Re: To Convert or not to convert- That is the question!
wthomas@g...
2005-03-06 12:22:05 UTC
Re: [CAD_CAM_EDM_DRO] W.E.T. -CNC safety
wthomas@g...
2005-03-06 12:27:43 UTC
Re:W.E.T.-Folding Handwheels
R Rogers
2005-03-06 14:25:08 UTC
Re: [CAD_CAM_EDM_DRO] Re:W.E.T.-Folding Handwheels
Earl White
2005-03-08 21:06:54 UTC
Re: [CAD_CAM_EDM_DRO] To Convert or not to convert- That is the question!
Earl White
2005-03-08 22:02:03 UTC
Re: [CAD_CAM_EDM_DRO] Re: To Convert or not to convert- That is the question!
cnc_4_me
2005-03-09 02:43:16 UTC
Re: To Convert or not to convert- That is the question!
Jon Elson
2005-03-09 10:27:32 UTC
Re: [CAD_CAM_EDM_DRO] To Convert or not to convert- That is the question!