Re: To Convert or not to convert- That is the question!
Posted by
cnc_4_me
on 2005-03-09 02:43:16 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Earl White" <eewhite4@k...>
wrote:
fallback position you can keep your existing acme screw and use
moglice to cast new nuts for your screws, making them neer zero
backlash. Try doing a search for moglice in the archives for more
info. Many good things have been said about it.
Wally
wrote:
> Very interesting!and if
>
> But now I have more questions than I did before!!
> Do you still use the existing leadscrews on a typical CNC retrofit?
> not, what do you replace them with?18
> Also, the table on my Clausing mill is only about 6 inches wide and
> inches long. would it be a good candidate for a CNC retrofit?The ideal soultion is to install anti backlash ballscrews. As a
>
> Earl White
> eewhite4@k...
> ----- Original Message -----
fallback position you can keep your existing acme screw and use
moglice to cast new nuts for your screws, making them neer zero
backlash. Try doing a search for moglice in the archives for more
info. Many good things have been said about it.
Wally
Discussion Thread
eewhite42000
2005-03-05 14:33:15 UTC
To Convert or not to convert- That is the question!
ernie7
2005-03-05 14:37:58 UTC
Re: [CAD_CAM_EDM_DRO] To Convert or not to convert- That is the question!
Ron
2005-03-05 22:10:40 UTC
Re: To Convert or not to convert- That is the question!
Jon Elson
2005-03-05 22:15:15 UTC
Re: [CAD_CAM_EDM_DRO] To Convert or not to convert- That is the question!
Polaraligned
2005-03-06 04:47:36 UTC
Re: To Convert or not to convert- That is the question!
wthomas@g...
2005-03-06 12:22:05 UTC
Re: [CAD_CAM_EDM_DRO] W.E.T. -CNC safety
wthomas@g...
2005-03-06 12:27:43 UTC
Re:W.E.T.-Folding Handwheels
R Rogers
2005-03-06 14:25:08 UTC
Re: [CAD_CAM_EDM_DRO] Re:W.E.T.-Folding Handwheels
Earl White
2005-03-08 21:06:54 UTC
Re: [CAD_CAM_EDM_DRO] To Convert or not to convert- That is the question!
Earl White
2005-03-08 22:02:03 UTC
Re: [CAD_CAM_EDM_DRO] Re: To Convert or not to convert- That is the question!
cnc_4_me
2005-03-09 02:43:16 UTC
Re: To Convert or not to convert- That is the question!
Jon Elson
2005-03-09 10:27:32 UTC
Re: [CAD_CAM_EDM_DRO] To Convert or not to convert- That is the question!