Help with servos and encoders from a printer
Posted by
Meyclan
on 2005-03-15 10:21:13 UTC
Hi,
I have 24VDC servo motors fitted with Opto encoders and Gecko G320 drives.
I recovered the from a Dataproducts printer,
Question can they connected as the encoders have six wires or must I replace them,
if so can anyone make a recomendation?
Regards ,
Kevin
[Non-text portions of this message have been removed]
I have 24VDC servo motors fitted with Opto encoders and Gecko G320 drives.
I recovered the from a Dataproducts printer,
Question can they connected as the encoders have six wires or must I replace them,
if so can anyone make a recomendation?
Regards ,
Kevin
[Non-text portions of this message have been removed]
Discussion Thread
Meyclan
2005-03-15 10:21:13 UTC
Help with servos and encoders from a printer
R Rogers
2005-03-15 11:46:52 UTC
Re: [CAD_CAM_EDM_DRO] Help with servos and encoders from a printer