Re: Re: Gearhead motors ? future drives ?

> > > I'm hoping that I can use Mariss' un-stop-able stepper drive
> logic
> > > to control the G320. The G100 should not care if it is a stepper
> or
> > > servo as long as it get encoder pulses.
> > >
> > > Roger
> >
> >
> > Funny, I chose not to use the multiplier for pretty much the same
> reason.
> >
>
>
> DeskCNC has been delivering 125,000, smooth, steps per second for
> the better part of a year, and 45,000 for 2 years before that.
>
>
> Fred Smith - IMService

Mach3 with Marris's new G200X is delivering 6 million steps per second.
Granted it not out yet commercially but the speed at which these two work it won't be long.
And more to the point it will have decent documentation.

> That gives you what? 600 ipm.

Six million steps per second should either give you heartburn or the brown trouser syndrome <g>

John S.



--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.308 / Virus Database: 266.11.10 - Release Date: 13/05/2005



This e-mail was scanned for viruses using BitDefender