Re: [CAD_CAM_EDM_DRO] Sizing a power supply

In a message dated 12-June-00 14:32:09 Central Daylight Time,
janders@... writes:

<< Would this be better that the 40v setup to justify switching over
until I can locate a 70v PS? (it's got outputs for several volt/amp
ratings, and a ton of wiring I wouldn't need and would strip out) YES.
Last question, would I really be better off building up separate
PS/driver, or can I run all three off a sinle PS just fine? >> this is two
questions! First, not necessarily, unless you could NOT get an adequate
SINGLE supply. Second: Yes, if it can put-out 3x7.5 continously. Maybe,
even only 20 Amp would do, as it is really unlikely that all three drives
will draw a total of 3x7.5A for very long, or often. But, then, I ain't
there! Jan Rowland, Troll