Re: Spindle Relay Question
Posted by
volitan712003
on 2005-05-26 15:06:12 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "turbulatordude"
<dave_mucha@y...> wrote:
change direction from the computer. It sounds like a mechanical relay
is the way to go.
I was going to try a digispeed on it for the speed.
Thanks to all who responded!
David
<dave_mucha@y...> wrote:
> I am not sure how you propose to run the motor. PWM out of the PCand
> PWM the SSR ?direction.
>
> For a few $$ you can buy a SCR driver for the motor (surplus center)
> and that can accept your PWM as the speed source.
>
> A single DPDT mechanical relay could be used to then reverse
>That's what I have. An SCR driver. I was only worried about how to
change direction from the computer. It sounds like a mechanical relay
is the way to go.
I was going to try a digispeed on it for the speed.
Thanks to all who responded!
David
Discussion Thread
volitan712003
2005-05-25 18:05:14 UTC
Spindle Relay Question
volitan712003
2005-05-25 18:38:45 UTC
Re: Spindle Relay Question
David Speck
2005-05-25 18:57:58 UTC
Re: [CAD_CAM_EDM_DRO] Re: Spindle Relay Question
JanRwl@A...
2005-05-25 19:43:36 UTC
Re: [CAD_CAM_EDM_DRO] Spindle Relay Question
turbulatordude
2005-05-25 19:44:39 UTC
Re: Spindle Relay Question
David Speck
2005-05-25 19:59:30 UTC
Re: [CAD_CAM_EDM_DRO] Spindle Relay Question
JanRwl@A...
2005-05-25 20:10:46 UTC
Re: [CAD_CAM_EDM_DRO] Spindle Relay Question
Codesuidae
2005-05-25 20:57:19 UTC
Re: [CAD_CAM_EDM_DRO] Re: Spindle Relay Question
ducatirod
2005-05-26 07:39:06 UTC
Re: Spindle Relay Question
spc_aux
2005-05-26 14:22:52 UTC
Re: Spindle Relay Question
JanRwl@A...
2005-05-26 14:26:55 UTC
Re: [CAD_CAM_EDM_DRO] Re: Spindle Relay Question
Codesuidae
2005-05-26 15:04:07 UTC
Re: [CAD_CAM_EDM_DRO] Re: Spindle Relay Question
volitan712003
2005-05-26 15:06:12 UTC
Re: Spindle Relay Question
volitan712003
2005-05-26 15:13:20 UTC
Re: Spindle Relay Question
JanRwl@A...
2005-05-26 21:45:36 UTC
Re: [CAD_CAM_EDM_DRO] Re: Spindle Relay Question
turbulatordude
2005-05-27 07:50:39 UTC
Re: Spindle Relay Question