CAD CAM EDM DRO - Yahoo Group Archive

Re: Spindle Relay Question

on 2005-05-27 07:50:39 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, JanRwl@A... wrote:
>
> In a message dated 5/26/2005 5:14:19 P.M. Central Daylight Time,
> volitan@o... writes:
>
> So I
> should be able to use that 12 volts to drive a mechanical relay,
> switched on and off with a small SSR that would be switched by the
> computer port?
>
>
>
> For that "small SSR" in this case use either the ULN2004 or the 75477.



Check the specs on the SSR, it may be able to be driven directly by
the Parallel Port. Many have an optoisolator as the input and only
need a few mA.

Dave

Discussion Thread

volitan712003 2005-05-25 18:05:14 UTC Spindle Relay Question volitan712003 2005-05-25 18:38:45 UTC Re: Spindle Relay Question David Speck 2005-05-25 18:57:58 UTC Re: [CAD_CAM_EDM_DRO] Re: Spindle Relay Question JanRwl@A... 2005-05-25 19:43:36 UTC Re: [CAD_CAM_EDM_DRO] Spindle Relay Question turbulatordude 2005-05-25 19:44:39 UTC Re: Spindle Relay Question David Speck 2005-05-25 19:59:30 UTC Re: [CAD_CAM_EDM_DRO] Spindle Relay Question JanRwl@A... 2005-05-25 20:10:46 UTC Re: [CAD_CAM_EDM_DRO] Spindle Relay Question Codesuidae 2005-05-25 20:57:19 UTC Re: [CAD_CAM_EDM_DRO] Re: Spindle Relay Question ducatirod 2005-05-26 07:39:06 UTC Re: Spindle Relay Question spc_aux 2005-05-26 14:22:52 UTC Re: Spindle Relay Question JanRwl@A... 2005-05-26 14:26:55 UTC Re: [CAD_CAM_EDM_DRO] Re: Spindle Relay Question Codesuidae 2005-05-26 15:04:07 UTC Re: [CAD_CAM_EDM_DRO] Re: Spindle Relay Question volitan712003 2005-05-26 15:06:12 UTC Re: Spindle Relay Question volitan712003 2005-05-26 15:13:20 UTC Re: Spindle Relay Question JanRwl@A... 2005-05-26 21:45:36 UTC Re: [CAD_CAM_EDM_DRO] Re: Spindle Relay Question turbulatordude 2005-05-27 07:50:39 UTC Re: Spindle Relay Question