CAD CAM EDM DRO - Yahoo Group Archive

Re: Spindle Relay Question

Posted by volitan712003
on 2005-05-25 18:38:45 UTC
Whoa nelly did I botch that post!

Let me be more clear. The drive will accept a 10 volt analog signal to
control the speed, so controlling the spindle via computer is no
problem.

The drive will not reverse the motor. The only way to do that is swap
the 2 power wires going to it (the motor). That's why I'm after (I
think) a DPDT relay. Just can't find one. Or else if anyone has any
better idea...

Sorry for the confusion

David






--- In CAD_CAM_EDM_DRO@yahoogroups.com, "volitan712003" <volitan@o...>
wrote:
> Hello again!
>
> I'm looking at relays for my computer to control my spindle. Its a
> brushless (PM) DC Motor. The drive will output at most 130VDC and
10A.

Discussion Thread

volitan712003 2005-05-25 18:05:14 UTC Spindle Relay Question volitan712003 2005-05-25 18:38:45 UTC Re: Spindle Relay Question David Speck 2005-05-25 18:57:58 UTC Re: [CAD_CAM_EDM_DRO] Re: Spindle Relay Question JanRwl@A... 2005-05-25 19:43:36 UTC Re: [CAD_CAM_EDM_DRO] Spindle Relay Question turbulatordude 2005-05-25 19:44:39 UTC Re: Spindle Relay Question David Speck 2005-05-25 19:59:30 UTC Re: [CAD_CAM_EDM_DRO] Spindle Relay Question JanRwl@A... 2005-05-25 20:10:46 UTC Re: [CAD_CAM_EDM_DRO] Spindle Relay Question Codesuidae 2005-05-25 20:57:19 UTC Re: [CAD_CAM_EDM_DRO] Re: Spindle Relay Question ducatirod 2005-05-26 07:39:06 UTC Re: Spindle Relay Question spc_aux 2005-05-26 14:22:52 UTC Re: Spindle Relay Question JanRwl@A... 2005-05-26 14:26:55 UTC Re: [CAD_CAM_EDM_DRO] Re: Spindle Relay Question Codesuidae 2005-05-26 15:04:07 UTC Re: [CAD_CAM_EDM_DRO] Re: Spindle Relay Question volitan712003 2005-05-26 15:06:12 UTC Re: Spindle Relay Question volitan712003 2005-05-26 15:13:20 UTC Re: Spindle Relay Question JanRwl@A... 2005-05-26 21:45:36 UTC Re: [CAD_CAM_EDM_DRO] Re: Spindle Relay Question turbulatordude 2005-05-27 07:50:39 UTC Re: Spindle Relay Question