Re: [CAD_CAM_EDM_DRO] Re: Thought I had it figured out!!

I wouldn't worry too much about an extra 5V, it can give you more speed
but if you do not call for it the Gecko will not deliver it. Think of
the 320 as a chopper power supply, it only outputs the voltage needed.
Ed.

pug_harley_corvette wrote:

>
> --- In CAD_CAM_EDM_DRO@yahoogroups.com, Ed Fanta <atex57@m...> wrote:
> Ed;
> Thanks for the info. I'm going to use the 320's and I just read the
> set up sheet that came with the shipment and it does state not to use
> a power supply higher than 5 volts above the motor rating (duh). I
> guess I should have figured out that the servo is nothing but a dc
> motor with an encoder. But, I'm bein cautious. Don't want to
> replace things right away. My transformwer has a 25 volt output
> which will yield a 35 volt dc output. Is there a loading resistor
> circuit I can go with to knock it down to 30. I don't want to
> regulate the supply as it seems not the way to go! Thanks for all
> the help.
> billyjack>