CAD CAM EDM DRO - Yahoo Group Archive

Re: 16mm Chuck needed...

on 2005-08-03 22:40:26 UTC
> Anyway, I have gotten to the point where I need to come up with
> something that will function as a spindle.
>
> In keeping with my approach I found a $25 precision spindle made by
> Issoku (for some Hitachi mill..don't know exactly which one).
>
> I have noticed that the "business end" is a 16mm (close to 5/8")
> diameter shaft with 1mm threads.
>
> I would like to put a chuck on this. Any idea if this is standard
> size. I realized that with the metric threads...I might find it hard
> to find a chuck to fit....but I wondered if you folks know of this as
> a standardly available size.
>
> Thanks.
>
> Jim


Is the shaft solid or hollow ? if it is hollow, there may be an
internal taper that is already for some readialy available part.

Can you elaborate a little on the shaft ?
pictures ?

you can put them on Yahoo's new, free flickr site
http://www.flickr.com/


Dave

Discussion Thread

jzmuda2000 2005-08-03 13:01:21 UTC 16mm Chuck needed... George Taylor, IV 2005-08-03 20:45:47 UTC RE: [CAD_CAM_EDM_DRO] 16mm Chuck needed... turbulatordude 2005-08-03 22:40:26 UTC Re: 16mm Chuck needed... jzmuda2000 2005-08-04 09:58:00 UTC Re: 16mm Chuck needed... curt_rxr 2005-08-05 07:52:50 UTC Re: 16mm Chuck needed... jzmuda2000 2005-08-07 09:35:20 UTC Re: 17mm Chuck needed...