Re: [CAD_CAM_EDM_DRO] Help on stepper drivers and programs - please

As far as the hardware connections try here.
http://www.armory.com/~rstevew There is a little project called Floppy bot
out there somewhere. I f no luck I can send what I have hacked up here on
file. I recently did this trying KellyCAM, but I had a problem with it
driving in one direction only. It also seems that DANCAM worked will but I
don't remember if it does G code I think it is HPGL import. Dam Mauch would
know as his article started me on this stuff.
Robert Ash
AOLIM - esccicq
ICQ# -5996165
Starting page with links to hobby shop and other images.
http://personal.lig.bellsouth.net/lig/e/s/esccmail/main.html
Streaming video of hobby shop normally on 6PM to 9PM EST

----- Original Message -----
From: "John Stevenson" <john@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Sent: Tuesday, June 20, 2000 7:32 AM
Subject: [CAD_CAM_EDM_DRO] Help on stepper drivers and programs - please


> I am currently looking at a simple 2 axis position and drill application.
> Two axis are need to position and the drill cycle is taken care of by a
> linear operated air drill which just requires a trigger signal plus a
> return signal at the end of the drill stroke before moving again.
> There are a lot of simple programs out there that use the parallel port
> which seems OK for my use. To try some of these out I need to actually
move
> a couple of steppers.
> I have been told that I can use an old hard drive for the stepper and
> driver.
> can anyone advise on pin connections for this. I don't actually need to
> drive anything only see it work at this stage.
> As regards programs I have seen Ahha, Flashcut, Ability, Deskcam NCrt and
> Max NC.
> The two main criteria that I need are the ability to use G code and to
work
> in metric.
> Is there any that I have missed?
> Please don't suggest EMC as I'm 52 already and would like to get this
> running before I retire <g>
> As a LOT of people far more experienced than me can't get either Linux or
> EMC running then I stand no chance.
> --
>
> Regards,
> John Stevenson
> Special Purpose Machines
> Nottingham, England
>
> ------------------------------------------------------------------------
> CLICK HERE AND START SAVING ON LONG DISTANCE BILLS TODAY!
> http://click.egroups.com/1/4125/3/_/423600/_/961504160/
> ------------------------------------------------------------------------
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>
>