Re: [CAD_CAM_EDM_DRO] Help on stepper drivers and programs - please
Posted by
Doug Fortune
on 2000-06-20 19:18:03 UTC
Robert wrote:
but it turned out to be: we had just connected the S&D parallel port pins to the
driver, BUT NOT A GROUND (ie a logical ground from the driver to one of the
ground pins on the stepper port). BTW KCam now supports defining
parallel pinouts to Step or Direction signals which makes it a lot easier
to configure (it used to be register bits to S&D signals).
Doug Fortune
> As far as the hardware connections try here.We had the same problem while playing with the free Windoze KCam (http://www.kellyware.com )
> http://www.armory.com/~rstevew There is a little project called Floppy bot
> out there somewhere. I f no luck I can send what I have hacked up here on
> file. I recently did this trying KellyCAM, but I had a problem with it
> driving in one direction only.
but it turned out to be: we had just connected the S&D parallel port pins to the
driver, BUT NOT A GROUND (ie a logical ground from the driver to one of the
ground pins on the stepper port). BTW KCam now supports defining
parallel pinouts to Step or Direction signals which makes it a lot easier
to configure (it used to be register bits to S&D signals).
Doug Fortune
Discussion Thread
Dan Mauch
2000-06-20 07:02:25 UTC
Re: [CAD_CAM_EDM_DRO] Help on stepper drivers and programs - please
Bob Campbell
2000-06-20 09:18:42 UTC
Re: [CAD_CAM_EDM_DRO] Help on stepper drivers and programs - please
Robert
2000-06-20 13:43:07 UTC
Re: [CAD_CAM_EDM_DRO] Help on stepper drivers and programs - please
Doug Fortune
2000-06-20 19:18:03 UTC
Re: [CAD_CAM_EDM_DRO] Help on stepper drivers and programs - please
Robert
2000-06-21 02:08:58 UTC
Re: [CAD_CAM_EDM_DRO] Help on stepper drivers and programs - please
wanliker@a...
2000-06-22 12:51:43 UTC
Re: [CAD_CAM_EDM_DRO] Help on stepper drivers and programs - please
Chris Paine
2000-07-08 19:35:40 UTC
Re: [CAD_CAM_EDM_DRO] Help on stepper drivers and programs - please