Re: [CAD_CAM_EDM_DRO] Re: help with steppers etc
Posted by
Ron Ginger
on 2000-06-21 06:58:11 UTC
Tim Goldstein wrote:
a new effort, that from notes posted here sounds a lot like beta code.
Promising, but maybe not quite ready for production use yet.
ron
>Note also that DeskNC has been around for quite awhile, but DeskNCrt is
> > Does anyone know what the difference is between DeskNC and DeskNCrt ?
>
> DeskNCrt is a port of the EMC code and is suppose to run on a real time
> version of DOS. It also has support for closed loop positioning using
> encoders that are read through the Kulaga/Mauch DRO card sold by Camtronics.
>
> DeskNC is not real time and has no support for encoders, but IMHO does have
> an easier to understand interface.
>
a new effort, that from notes posted here sounds a lot like beta code.
Promising, but maybe not quite ready for production use yet.
ron
Discussion Thread
Ron Ginger
2000-06-20 14:19:36 UTC
Re: [CAD_CAM_EDM_DRO] Re: help with steppers etc
joe
2000-06-20 14:25:46 UTC
Re: [CAD_CAM_EDM_DRO] Re: help with steppers etc
psp@p...
2000-06-20 14:52:22 UTC
Re: [CAD_CAM_EDM_DRO] Re: help with steppers etc
Tim Goldstein
2000-06-20 15:40:19 UTC
RE: [CAD_CAM_EDM_DRO] Re: help with steppers etc
Steve Carlisle
2000-06-20 18:24:33 UTC
Re: [CAD_CAM_EDM_DRO] Re: help with steppers etc
Dan Mauch
2000-06-21 06:23:44 UTC
Re: [CAD_CAM_EDM_DRO] Re: help with steppers etc
Ron Ginger
2000-06-21 06:58:11 UTC
Re: [CAD_CAM_EDM_DRO] Re: help with steppers etc