Re: [CAD_CAM_EDM_DRO] When
Posted by
wanliker@a...
on 2000-06-23 13:22:54 UTC
In a message dated 6/23/00 1:57:44 PM Mountain Daylight Time,
ginger@... writes:
<<
The documentation Ray announced earlier today will help make it a lot
easier, but it is always going to be hard for the computer novice. >>
It is my understanding the reason for EMC, was the transfer of technology to
small manufacturers, if this is so, it will never happen until it is easy for
them to implement. Most small business are not computer literate enough to
make the present method work. I think an addition effort on the EMC part is
to provide a system that will work easily with out all the present
difficulties.
bill
ginger@... writes:
<<
The documentation Ray announced earlier today will help make it a lot
easier, but it is always going to be hard for the computer novice. >>
It is my understanding the reason for EMC, was the transfer of technology to
small manufacturers, if this is so, it will never happen until it is easy for
them to implement. Most small business are not computer literate enough to
make the present method work. I think an addition effort on the EMC part is
to provide a system that will work easily with out all the present
difficulties.
bill
Discussion Thread
Tim Goldstein
2000-06-23 12:52:38 UTC
RE: [CAD_CAM_EDM_DRO] When
Ron Ginger
2000-06-23 12:54:43 UTC
Re: [CAD_CAM_EDM_DRO] When
wanliker@a...
2000-06-23 13:22:54 UTC
Re: [CAD_CAM_EDM_DRO] When
wanliker@a...
2000-06-23 13:24:09 UTC
Re: [CAD_CAM_EDM_DRO] When