Re: [CAD_CAM_EDM_DRO] Emco VMC-100

This might be worth a try although your talking about
an older machine (current one is probable the 105).

http://www.emco.co.uk/index.htm

----- Original Message -----
From: "paul2112_98" <paul2112_98@...>

Subject: [CAD_CAM_EDM_DRO] Emco VMC-100


>I was wondering if anyone has experience of setting up a VMC-100. I
> bought the machine knowing it had several faults including bad
> electronics but I now have all 3 axis moving and the machine is able
> to reference. The problem now is that if I try to either start the
> spindle or rotate the tool shop the servo drive (aux) psu contactor
> drops out and a H15 LED alarm (position overrun) is indicated on the
> servo amp control board, once the aux psu drops out then I get a
> refence alarm 460 and I'm back to square one. I spoke with a machine
> service company and their advice was to reload MSD which I did but
> made no difference. Can anyone shed any light as to what could be
> causing this?
>
> Thanks,
> Paul