Re: [CAD_CAM_EDM_DRO] Emco VMC-100

paul2112_98 wrote:

>I was wondering if anyone has experience of setting up a VMC-100. I
>bought the machine knowing it had several faults including bad
>electronics but I now have all 3 axis moving and the machine is able
>to reference. The problem now is that if I try to either start the
>spindle or rotate the tool shop the servo drive (aux) psu contactor
>drops out and a H15 LED alarm (position overrun) is indicated on the
>servo amp control board, once the aux psu drops out then I get a
>refence alarm 460 and I'm back to square one. I spoke with a machine
>service company and their advice was to reload MSD which I did but
>made no difference. Can anyone shed any light as to what could be
>causing this?
>
>

Position overrun sounds like one of the travel limit switches is too
sensitive
to electrical noise, or possibly even vibration. You might check if any
cable shielding has gone bad, and that necessary pullup resistors are
set up properly on the inputs for the limit switches.

I don't know what the alarm 460 is, it just may mean you need to rehome
after what it thinks is a crash.

Jon