CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: emc2 BDI-4.xx (configure probs)-nomore

on 2005-10-04 09:14:42 UTC
Just to interject here KDE is extremely resource hungery! Personally
I don't use it anywhere though that is certainly a personal
preference. On PC's used for control work I'd have to suggest not
using KDE even if you prefer it.

If like most of us you are using older PC hardware for your control
functions or are buying lower cost units, avoiding the overhead of a
busy environment makes good sense.

Thanks
Dave

Thos J Powderly wrote:

>Paul,
>Thanks again,
>A fresh dload of BDI-4.30 installed fine & emc2 is up and running on it
>I added a few notes to the WIKI page on the emc2 build
>( things that confused me and maybe others)
>Works great
>I used XFCE and it may be my imagination,
> but downloads, cvs checkouts and compiles seemed a lot faster.
>I had always used KDE and turned off all the eye candy before.
>TomP
>
>
>Addresses:
>FAQ: http://www.ktmarketing.com/faq.html
>FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>Post Messages: CAD_CAM_EDM_DRO@yahoogroups.com
>
>Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
>List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@..., timg@...
>Moderator: pentam@... indigo_red@... davemucha@... [Moderators]
>URL to this group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>
>OFF Topic POSTS: General Machining
>If you wish to post on unlimited OT subjects goto: aol://5863:126/rec.crafts.metalworking or go thru Google.com to reach it if you have trouble.
>http://www.metalworking.com/news_servers.html
>
>http://groups.yahoo.com/group/jobshophomeshop I consider this to be a sister site to the CCED group, as many of the same members are there, for OT subjects, that are not allowed on the CCED list.
>
>NOTICE: ALL POSTINGS TO THIS GROUP BECOME PUBLIC DOMAIN BY POSTING THEM. DON'T POST IF YOU CAN NOT ACCEPT THIS.....NO EXCEPTIONS........
>bill
>List Mom
>List Owner
>
>
>Yahoo! Groups Links
>
>
>
>
>
>
>
>
>
>

Discussion Thread

Thos J Powderly 2005-10-03 15:33:08 UTC Re: emc2 BDI-4.xx (configure probs)-nomore David A. Frantz 2005-10-04 09:14:42 UTC Re: [CAD_CAM_EDM_DRO] Re: emc2 BDI-4.xx (configure probs)-nomore