Re: [CAD_CAM_EDM_DRO] Stepper motor torque
Posted by
Tony Smith
on 2005-10-25 16:40:47 UTC
> Hi,I'd say 150 oz in.
>
> How much torque could I expect from a Type 34, 150 oz in. (2.9 volt 3.1
> amp)
> unipolar stepper running at 400 rpm using the HobbyCNC 3A chopper drive. A
> ball park figure would do.
>
> Regards,
>
> Terry
Tony
Discussion Thread
Blue
2005-10-25 16:23:46 UTC
Stepper motor torque
Tony Smith
2005-10-25 16:40:47 UTC
Re: [CAD_CAM_EDM_DRO] Stepper motor torque
R Rogers
2005-10-25 17:15:54 UTC
Re: [CAD_CAM_EDM_DRO] Stepper motor torque
Dan Mauch
2005-10-25 19:38:23 UTC
Re: [CAD_CAM_EDM_DRO] Stepper motor torque