Re: micro wire-edm project (and software solution)
Posted by
turbulatordude
on 2005-10-30 08:38:49 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "viewpanel1" <viewpanel1@y...>
wrote:
http://www.fairchildsemi.com/ds/1N/1N4004.pdf
I have seen enough differences to know to measure. But, you are
correct that no one value is correct. And that one should not use
these posts as engineering facts, but should consult the data sheets
for the manufacturers data.
Dave
wrote:
>The Fairchild 1N4004 data sheet shows the drop as 1.1 volts at 1 amps.
> Dave in my times the silicon diode drop voltage was .7 volts. Hope
> still the same
> Jose
http://www.fairchildsemi.com/ds/1N/1N4004.pdf
I have seen enough differences to know to measure. But, you are
correct that no one value is correct. And that one should not use
these posts as engineering facts, but should consult the data sheets
for the manufacturers data.
Dave
Discussion Thread
Graham Stabler
2005-10-27 08:33:32 UTC
micro wire-edm project (and software solution)
turbulatordude
2005-10-27 11:17:41 UTC
Re: micro wire-edm project (and software solution)
Graham Stabler
2005-10-27 13:36:20 UTC
Re: micro wire-edm project (and software solution)
turbulatordude
2005-10-27 20:36:07 UTC
Re: micro wire-edm project (and software solution)
Graham Stabler
2005-10-28 02:12:01 UTC
Re: micro wire-edm project (and software solution)
turbulatordude
2005-10-28 05:34:39 UTC
Re: micro wire-edm project (and software solution)
JCullins
2005-10-28 06:43:06 UTC
Re: [CAD_CAM_EDM_DRO] Re: micro wire-edm project (and software solution)
turbulatordude
2005-10-28 07:43:06 UTC
Re: micro wire-edm project (and software solution)
Dan Mauch
2005-10-28 08:39:44 UTC
Re: [CAD_CAM_EDM_DRO] Re: micro wire-edm project (and software solution)
JCullins
2005-10-28 08:40:01 UTC
Re: [CAD_CAM_EDM_DRO] Re: micro wire-edm project (and software solution)
JCullins
2005-10-28 09:12:31 UTC
Re: [CAD_CAM_EDM_DRO] Re: micro wire-edm project (and software solution)
Mark
2005-10-29 05:04:24 UTC
Re: micro wire-edm project (and software solution)
viewpanel1
2005-10-30 07:39:22 UTC
Re: micro wire-edm project (and software solution)
turbulatordude
2005-10-30 08:38:49 UTC
Re: micro wire-edm project (and software solution)
Graham Stabler
2005-10-30 13:50:49 UTC
Re: micro wire-edm project (and software solution)