Re: micro wire-edm project (and software solution)
Posted by
Graham Stabler
on 2005-10-30 13:50:49 UTC
but still not "very big" and still invariable.
Graham
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "turbulatordude"
<dave_mucha@y...> wrote:
Graham
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "turbulatordude"
<dave_mucha@y...> wrote:
><viewpanel1@y...>
> --- In CAD_CAM_EDM_DRO@yahoogroups.com, "viewpanel1"
> wrote:Hope
> >
> > Dave in my times the silicon diode drop voltage was .7 volts.
> > still the sameamps.
> > Jose
>
> The Fairchild 1N4004 data sheet shows the drop as 1.1 volts at 1
>
> http://www.fairchildsemi.com/ds/1N/1N4004.pdf
>
> I have seen enough differences to know to measure. But, you are
> correct that no one value is correct. And that one should not use
> these posts as engineering facts, but should consult the data sheets
> for the manufacturers data.
>
> Dave
>
Discussion Thread
Graham Stabler
2005-10-27 08:33:32 UTC
micro wire-edm project (and software solution)
turbulatordude
2005-10-27 11:17:41 UTC
Re: micro wire-edm project (and software solution)
Graham Stabler
2005-10-27 13:36:20 UTC
Re: micro wire-edm project (and software solution)
turbulatordude
2005-10-27 20:36:07 UTC
Re: micro wire-edm project (and software solution)
Graham Stabler
2005-10-28 02:12:01 UTC
Re: micro wire-edm project (and software solution)
turbulatordude
2005-10-28 05:34:39 UTC
Re: micro wire-edm project (and software solution)
JCullins
2005-10-28 06:43:06 UTC
Re: [CAD_CAM_EDM_DRO] Re: micro wire-edm project (and software solution)
turbulatordude
2005-10-28 07:43:06 UTC
Re: micro wire-edm project (and software solution)
Dan Mauch
2005-10-28 08:39:44 UTC
Re: [CAD_CAM_EDM_DRO] Re: micro wire-edm project (and software solution)
JCullins
2005-10-28 08:40:01 UTC
Re: [CAD_CAM_EDM_DRO] Re: micro wire-edm project (and software solution)
JCullins
2005-10-28 09:12:31 UTC
Re: [CAD_CAM_EDM_DRO] Re: micro wire-edm project (and software solution)
Mark
2005-10-29 05:04:24 UTC
Re: micro wire-edm project (and software solution)
viewpanel1
2005-10-30 07:39:22 UTC
Re: micro wire-edm project (and software solution)
turbulatordude
2005-10-30 08:38:49 UTC
Re: micro wire-edm project (and software solution)
Graham Stabler
2005-10-30 13:50:49 UTC
Re: micro wire-edm project (and software solution)