VectorCam
Posted by
nky@g...
on 2000-06-26 13:42:49 UTC
Is anyone in the group working with VectorCam?
I have used the sherline manual lathe and mills extensively for
jewelery modeling and want to move to CNC. (I'll be using a
MicroKinetics 4 axis mill)
The only software I've played with so far has been BobCad.
They were kind enough to send me a demo. Shortly after that, I
started receiving invoices for about $700, and they were calling
daily and demanding that I PAY them for the software. They
claimed that I had ordered the full version, faxed them a copy of a
check, then never sent the check.
Only problem was, that was a complete lie, and everytime I
asked for a copy of the supposed fax, I got the run around. I
finally threatened to sue them if I got one more phonecall, and
reported them to the BBB. Haven't heard from them since.
Needless to say, I am looking for alternatives and have heard
mention of Vector Cam. I have no CAD experience but am
extremely computer literate.
Any info would be greatly appreciated.
NKY
I have used the sherline manual lathe and mills extensively for
jewelery modeling and want to move to CNC. (I'll be using a
MicroKinetics 4 axis mill)
The only software I've played with so far has been BobCad.
They were kind enough to send me a demo. Shortly after that, I
started receiving invoices for about $700, and they were calling
daily and demanding that I PAY them for the software. They
claimed that I had ordered the full version, faxed them a copy of a
check, then never sent the check.
Only problem was, that was a complete lie, and everytime I
asked for a copy of the supposed fax, I got the run around. I
finally threatened to sue them if I got one more phonecall, and
reported them to the BBB. Haven't heard from them since.
Needless to say, I am looking for alternatives and have heard
mention of Vector Cam. I have no CAD experience but am
extremely computer literate.
Any info would be greatly appreciated.
NKY