CAD CAM EDM DRO - Yahoo Group Archive

Re: Linux install

Posted by Jeff Rossel
on 2000-07-03 08:30:20 UTC
Go to cheapbytes.com, you should be able to get a low cost/nocost RH
5.2 distro.

Jeff


--- In CAD_CAM_EDM_DRO@egroups.com, "Andrew Kozlowski"
<akozlows@r...> wrote:
> I would be intersted in installing EMC, if I could get a copy of
the Red Hat software I would be willing to give it a try. A P133
would be used for a small stepper driven
mill.

>
Andy
>
>
> [Non-text portions of this message have been removed]

Discussion Thread

Wayde Gutman 2000-06-18 15:26:53 UTC Linux install Andrew Kozlowski 2000-07-02 18:42:49 UTC Linux install Tim Goldstein 2000-07-02 19:09:08 UTC RE: [CAD_CAM_EDM_DRO] Linux install Jeff Rossel 2000-07-03 08:30:20 UTC Re: Linux install