Re: [CAD_CAM_EDM_DRO] Re: Linux install

Thanks for the information, all I was finding was RedHat 6.2.

Andy

----- Original Message -----
From: Jeff Rossel <jeffrossel@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Sent: Monday, July 03, 2000 10:30 AM
Subject: [CAD_CAM_EDM_DRO] Re: Linux install


> Go to cheapbytes.com, you should be able to get a low cost/nocost RH
> 5.2 distro.
>
> Jeff
>
>
> --- In CAD_CAM_EDM_DRO@egroups.com, "Andrew Kozlowski"
> <akozlows@r...> wrote:
> > I would be intersted in installing EMC, if I could get a copy of
> the Red Hat software I would be willing to give it a try. A P133
> would be used for a small stepper driven
> mill.
>
> >
> Andy
> >
> >
> > [Non-text portions of this message have been removed]
>
>
> ------------------------------------------------------------------------
> Lonely? Get Firetalk!
> Free, unlimited calls anywhere in the world.
> Free voice chat on hundreds of topics.
> http://click.egroups.com/1/5477/4/_/423600/_/962638220/
> ------------------------------------------------------------------------
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>
>