Re: [CAD_CAM_EDM_DRO] Udated DRO
Posted by
A. G. Eckstein
on 2000-07-03 09:25:29 UTC
I have now updated the page to show in schematic form, the path the cable
takes. On the sketch, the cable is in red and the black circles are the
axles/pulleys; with the green hash marks representing tie points. Hope this
helps..
Art
At 12:03 AM 7/1/00 EDT, you wrote:
Country Bubba
(Actually the inventor of Country and Bubba)
axtein@...
takes. On the sketch, the cable is in red and the black circles are the
axles/pulleys; with the green hash marks representing tie points. Hope this
helps..
Art
At 12:03 AM 7/1/00 EDT, you wrote:
>In a message dated 6/30/00 9:47:53 PM Mountain Daylight Time,OLDER THAN DIRT
>axtein@... writes:
>
><<
> If anyone is interested, I have updated my web page to reflect how it was
> done and can be seen at:
> >>
>Could elaborate a bit more on how you ran the cables to get these results.
>Thanks,
>bill
>
Country Bubba
(Actually the inventor of Country and Bubba)
axtein@...
Discussion Thread
wanliker@a...
2000-06-30 21:04:03 UTC
Re: [CAD_CAM_EDM_DRO] Udated DRO
A. G. Eckstein
2000-07-03 09:25:29 UTC
Re: [CAD_CAM_EDM_DRO] Udated DRO
A. G. Eckstein
2000-07-03 09:32:55 UTC
Re: [CAD_CAM_EDM_DRO] Udated DRO
wanliker@a...
2000-07-03 22:56:04 UTC
Re: [CAD_CAM_EDM_DRO] Udated DRO
John Guenther
2000-07-04 05:25:38 UTC
RE: [CAD_CAM_EDM_DRO] Udated DRO
Bob Bachman
2000-07-06 14:05:30 UTC
Re: [CAD_CAM_EDM_DRO] Udated DRO
A. G. Eckstein
2000-07-06 14:31:08 UTC
Re: [CAD_CAM_EDM_DRO] Udated DRO
Bob Bachman
2000-07-06 17:56:14 UTC
Re: [CAD_CAM_EDM_DRO] Udated DRO
A. G. Eckstein
2000-07-07 03:37:44 UTC
Re: [CAD_CAM_EDM_DRO] Udated DRO
Ian Wright
2000-07-07 11:37:08 UTC
Re: [CAD_CAM_EDM_DRO] Udated DRO
A. G. Eckstein
2000-07-07 14:07:07 UTC
Re: [CAD_CAM_EDM_DRO] Udated DRO
Alison & Jim Gregg
2000-07-08 21:27:16 UTC
Re: [CAD_CAM_EDM_DRO] Udated DRO