CAD CAM EDM DRO - Yahoo Group Archive

Re: Should I replace my encoders??

Posted by Vince Endter
on 2006-03-06 20:04:03 UTC
> I appreciate the advise. I will look into new encoders. Does anyone
have
> any recommendations? I hear US digital are pretty good.

If you plan on using a Gecko drive, Mariss says that they have a
current limit to encoder of 50 mA. Most of the encoders I looked at
take more than that. I ended up getting an US Digital E5Sxxxxxxx. You
have to determine the encoder shaft diameter. The ones I got were 1/4"
and had 500 lines/R. I think they were $54 each, plus $5 for an
alignment tool plus $4 each for connectors. Give them a call and they
can walk you through the encoder selection process.

Vince

Discussion Thread

oldpayphones 2006-03-04 23:15:50 UTC Should I replace my encoders?? Les Newell 2006-03-05 01:55:41 UTC Re: [CAD_CAM_EDM_DRO] Should I replace my encoders?? Patrick J 2006-03-05 03:26:01 UTC Re: [CAD_CAM_EDM_DRO] Should I replace my encoders?? Larry Olson 2006-03-05 21:11:41 UTC RE: [CAD_CAM_EDM_DRO] Should I replace my encoders?? Vince Endter 2006-03-06 20:04:03 UTC Re: Should I replace my encoders??