CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: Contouring in EMC

Posted by Jon Elson
on 2000-07-03 12:11:07 UTC
johndroc@... wrote:

> Oh man, that last line hurt! DEC 20 was the last version to work with
>
> servos? FYI - Fred and Will were back, but they're email server had
> crashed.
> Chances are, if they're messages weren't lost altogether, they have an
>
> enormous backlog of email to read. Try sending it again.

Oh, that explains why I haven't heard anything. I will pull back those
messages and send them again. They need to know about some
of the deficiencies in the later releases of EMC, in that they don't
perform well at all with servos (or even run reliably).

Thanks,

Jon

Discussion Thread

johndroc@a... 2000-07-03 05:24:47 UTC Re: [CAD_CAM_EDM_DRO] Re: Contouring in EMC johndroc@a... 2000-07-03 06:29:44 UTC Re: [CAD_CAM_EDM_DRO] Re: Contouring in EMC Jon Elson 2000-07-03 12:11:07 UTC Re: [CAD_CAM_EDM_DRO] Re: Contouring in EMC