Re: [CAD_CAM_EDM_DRO] Re: Lathe controller about mictokinetics
Posted by
Darrell
on 2000-07-03 12:21:01 UTC
I am running a YAM 14" swing by 28" lathe that has servos with encoders. I
am driving the servos with the ahha software through Oregon Microsystems
step and direction servo drivers. The ahha software will run in either inch
or metric mode.
Darrell
am driving the servos with the ahha software through Oregon Microsystems
step and direction servo drivers. The ahha software will run in either inch
or metric mode.
Darrell
----- Original Message -----
From: <john@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Sent: Monday, July 03, 2000 11:38 AM
Subject: [CAD_CAM_EDM_DRO] Re: Lathe controller about mictokinetics
>
> > john@m... wrote:
> > >
> > > Can anyone recomend a controller for a lathe other than Ahha.
> >
> > Microkinetics is the only one I know of, and I can say only that I
> > -think- it'll thread. Next step up appears to be a pretty high
> one.
> >
> > John, not Jon
> >
> > TELL ME MORE ABOUT THE LATHE YOU PLAN TO BUILD AND I CAN TELL YOY
> IF THE OPTISTEP CARD WILL WORK FOR YOU.
> >
> > FURTHER DON'T EXPECT SUPPORT FROM THE COMPANY
> >
> >
> > REGARDS
> >
> >
> > BYRON DAMANIA
>
> I'm looking at retrofitting am existing CNC lathe that is on servo's
> with resolvers at present but if nessesary I can change these to
> servo's with encoders or steppers.
> It must be able to use the spindle encoder to thread and accept
> industry standard G code - no closed loop software.
> Lathe size is 12" swing by 36" between centres.
> MUST operate in metric mode.
>
>
> ------------------------------------------------------------------------
> Lonely? Get Firetalk!
> Free, unlimited calls anywhere in the world.
> Free voice chat on hundreds of topics.
> http://click.egroups.com/1/5477/4/_/423600/_/962649487/
> ------------------------------------------------------------------------
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>
>
Discussion Thread
Darrell
2000-07-03 12:21:01 UTC
Re: [CAD_CAM_EDM_DRO] Re: Lathe controller about mictokinetics
john@m...
2000-07-03 12:27:47 UTC
Re: Lathe controller about mictokinetics
Darrell
2000-07-03 13:00:24 UTC
Re: [CAD_CAM_EDM_DRO] Re: Lathe controller about mictokinetics