Re: [CAD_CAM_EDM_DRO] Re: Lathe controller about mictokinetics

Oregon Micro Systems, Inc.
http://wwwomsmotion.com
I am using the MD400 but I just went to their site and it is not listed. It
is 80 volt 20 amp max rated. I hope it has not been discontinued.
Darrell

----- Original Message -----
From: <john@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Sent: Monday, July 03, 2000 12:27 PM
Subject: [CAD_CAM_EDM_DRO] Re: Lathe controller about mictokinetics


> --- In CAD_CAM_EDM_DRO@egroups.com, "Darrell" <dgehlsen@e...> wrote:
> > I am running a YAM 14" swing by 28" lathe that has servos with
> encoders. I
> > am driving the servos with the ahha software through Oregon
> Microsystems
> > step and direction servo drivers. The ahha software will run in
> either inch
> > or metric mode.
>
> Darrell
> Thanks, Any more info available on the drivers,Tried a web search on
> Oregon Microsystem but came up blank.
>
>
>
> ------------------------------------------------------------------------
> 0% Introductory APR!
> Instant Approval!
> Aria Visa - get yours today.
> http://click.egroups.com/1/6035/4/_/423600/_/962652468/
> ------------------------------------------------------------------------
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>
>