Re: [CAD_CAM_EDM_DRO] ACAD 2002
Posted by
Hal Eckhart
on 2006-05-06 07:46:37 UTC
On 5/6/06 12:28 AM, Blue wrote:
ago that ACAD uses ACIS entities for solids, which may not be supported by some
3D programs (Intellicad, if I recall correctly). I believe that Rhino has ACIS
support.
Hal Eckhart - Casa Forge - Minneapolis MN - <http://www.casaforge.com>
>I'm using ACAD 2002 and drawing in solids ... Why can no-one see myI don't know how to fix the problem from your end, but I recall from many years
>drawings when I send them as Dxf's, is there a setting I can change
>to make this happen.
ago that ACAD uses ACIS entities for solids, which may not be supported by some
3D programs (Intellicad, if I recall correctly). I believe that Rhino has ACIS
support.
Hal Eckhart - Casa Forge - Minneapolis MN - <http://www.casaforge.com>
Discussion Thread
Blue
2006-05-05 16:50:08 UTC
ACAD 2002
Darren Lucke
2006-05-05 17:00:32 UTC
Re: [CAD_CAM_EDM_DRO] ACAD 2002
wthomas@g...
2006-05-05 19:50:52 UTC
W.E.T. [CAD_CAM_EDM_DRO] ACAD 2002 Helix?
Lester Caine
2006-05-05 22:45:02 UTC
Re: [CAD_CAM_EDM_DRO] ACAD 2002
abcv avde
2006-05-06 05:20:53 UTC
Re: [CAD_CAM_EDM_DRO] ACAD 2002
R Rogers
2006-05-06 06:14:51 UTC
Re: [CAD_CAM_EDM_DRO] ACAD 2002
Hal Eckhart
2006-05-06 07:46:37 UTC
Re: [CAD_CAM_EDM_DRO] ACAD 2002
Fred Smith
2006-05-06 08:11:48 UTC
Re: ACAD 2002
abcv avde
2006-05-06 11:35:09 UTC
Re: [CAD_CAM_EDM_DRO] ACAD 2002
Blue
2006-05-06 17:21:00 UTC
Re: [CAD_CAM_EDM_DRO] ACAD 2002