Re: [CAD_CAM_EDM_DRO] STG2
Posted by
johndroc@a...
on 2000-07-07 09:50:07 UTC
In a message dated 7/7/00 12:41:27 PM Eastern Daylight Time,
dgehlsen@... writes:
<< While I have not used the STG card, I do remember that the STG 2 uses
different files in EMC than the STG card. Are you using the correct files
for your card?
Darrell >>
Yes, I definitely have the right setup. It works for the X axis (DAC0 in the
card).
dgehlsen@... writes:
<< While I have not used the STG card, I do remember that the STG 2 uses
different files in EMC than the STG card. Are you using the correct files
for your card?
Darrell >>
Yes, I definitely have the right setup. It works for the X axis (DAC0 in the
card).
Discussion Thread
Darrell
2000-07-07 09:40:08 UTC
Re: [CAD_CAM_EDM_DRO] STG2
johndroc@a...
2000-07-07 09:50:07 UTC
Re: [CAD_CAM_EDM_DRO] STG2
Jon Elson
2000-07-07 12:18:16 UTC
Re: [CAD_CAM_EDM_DRO] STG2
johndroc@a...
2000-07-07 13:27:49 UTC
Re: [CAD_CAM_EDM_DRO] STG2
Doug Yeager
2000-07-07 16:06:06 UTC
cncpro and ACEconverter on ebay