Re: [CAD_CAM_EDM_DRO] PIC-SERVO CNC controllers
Posted by
andrew abken
on 2000-07-08 19:59:19 UTC
Hi,
I am currently using Pic servos on a three axis minimill, and I like the
servo drives very much. I am driving them with step/dir control from EMC. I
have used the example machine control program offered by jr-kerr, but being
that it DOES NOT support backlash compensation found it to be unusable as a
control program, but I am learning c++ just so that I can modify it as
needed, it has lots of potential.
Any questions? just ask.
Andrew
kn6za
________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com
I am currently using Pic servos on a three axis minimill, and I like the
servo drives very much. I am driving them with step/dir control from EMC. I
have used the example machine control program offered by jr-kerr, but being
that it DOES NOT support backlash compensation found it to be unusable as a
control program, but I am learning c++ just so that I can modify it as
needed, it has lots of potential.
Any questions? just ask.
Andrew
kn6za
________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com
Discussion Thread
mSperry
2000-07-06 20:32:51 UTC
Re: [CAD_CAM_EDM_DRO] PIC-SERVO CNC controllers
andrew abken
2000-07-08 19:59:19 UTC
Re: [CAD_CAM_EDM_DRO] PIC-SERVO CNC controllers
mSperry
2000-07-08 20:08:54 UTC
Re: [CAD_CAM_EDM_DRO] PIC-SERVO CNC controllers